Home /
NEC NC2500S DLP Cinema projector

NEC NC2500S DLP Cinema projector

Altre viste

Disponibilità: Non disponibile

NEC NC2500S DLP Cinema projector

Descrizione

Dettagli

NEC NC2500S DLP Cinema projector

Projection method

3-chip DLP chip reflection method

DLP chip specifications

1.2", 12° tilt angle, 2048 x 1080 pixels

Light Output ^*1

26,000 Lumens^*2

Supported screen sizes

minimum

-at screen gain 1.3 / 14ft-l　12 meters (40 feet) ^*3 ^*4

maximum

-at screen gain 1.8 / 14ft-l　30 meters(100 feet) ^*2^*5
-at screen gain 1.3 / 14ft-l　25 meters (82 feet) ^{*2 *5}

Contrast ratio

2000 : 1 or above (full on / off)

Primary lenses

1.25 to 1.45:1 zoom "L2K-12ZM" ^*6

(Note : select according to magnifications of installation environment)

1.45 to 1.8:1 zoom "L2K-14ZM" ^*6

1.8 to 2.4:1 zoom "L2K-18ZM"

2.2 to 3.0:1 zoom "L2K-22ZM"

3.0 to 4.3:1 zoom "L2K-30ZM"

Lamp bulbs

NEC High efficiency Xenon lamp bulbs
　• NEC 6.0 kW lamp bulb "NC-LP6001"
　• NEC 4.5 kW lamp bulb "NC-LP4501"
Select according to installation conditions
NEC recommends the use of NEC lamp bulbs in order to maximize luminance efficiency

Standard film lamp bulbs^*7

DLP Cinema functions

CineLink^TM, CineCanvas^TM, CinePalette^TM, CineBlack^TM

Lens adjustment functions

Motorized focus, zoom, horizontal/vertical shift*, light shutter(dowser)
*Range of motorized shift is dependent on lens

Cooling method

　• Liquid cooling system inside, air cooling system with dust preventing
electrostatic filter.
　• Total thermal dissipation: 30539BTU
　　(Input 7KW power to NEC 6.0KW lamp bulb)
　• Projector exhaust : 424CFM (cubic foot per minute)
　• Demand of exhaust duct : 565CFM (cubic foot per minute)

Fan noise

Less than 65 dB

Power supply voltage^*8

　• Projector head : 200 to 240V AC, 50/60Hz, single phase
　• Lamp power supply unit : 200 to 230V / 380 to 415V AC, 50/60Hz, 3 phases

Rated input current

Projector head : 5A Max
Lamp power supply unit : 28A Max

Power consumption

Projector head : 950W
Lamp power supply unit : 8000W

Environment

Operational temperatures

10°C to 35°C( 41°F to 95°F), humidity : 10% to 80% (non- condensing)

Storage temperatures

-10°C to 50°C(14°F to 122°F), humidity : 10% to 80% (non-condensing)

Regulations

USA	UL60950 FCC Class A
Canada	CSA60950 ICES-003 Class A
Europe	EN60950 EN55022 1998, Class A EN55024-1998, EN61000-3-2, EN61000-3-3
Oceania	EN60950 AS/NZS 3548 Class A 1995 + A1/2:1997
Japan	J60950 VCCI Class A
Asia	EN60950 CISPR Pub22

External dimensions

Projector head :
700 (W) x 1100 (D) x 503 (H) (mm)
27.6(W) x 43.3(D) x 19.8(H) (inch)
*Excluding lens, lens hood and exhaust stack.

Lamp power supply unit :
596(W) x 397(D) x 471(H) (mm)
23.5(W) x 15.7(D) x 18.6(H) (inch)

Projector head + Pedestal (NEC Option) :
700 (W) x 1100 (D) x 1367 (H) (mm)
27.6(W) x 43.3(D) x 53.5(H) (inch)
*Excluding lens, lens hood, exhaust stack and handle.
Including foot.

Weight

　• Projector head : Approx.120kg / 265lb
　 *Excluding lens.

　• Lamp power supply unit : Approx. 50.5kg / 112 lb

　• Projector head + Pedestal(NEC Option) : Approx. 255.5kg / 564 lb
　 *Including Lamp power supply unit

*1	Measured at center screen
*2	Subject to installation conditions.This can be achieved using NEC 6.0Kw lamp bulb "NC-LP6001"
*3	Subject to installation conditions
*4	When using 3kw film projector lamp bulb
*5	When using anamorphic lens
*6	Anamorphic lens cannot be used with following primary lenses due to the limitation of the anamorphic lens (for NC2500S) 1.25 to 1.45 : 1 zoom "L2K-12ZM" 1.45 to 1.8 : 1 zoom "L2K-14ZM" For Cinema Scope (CS) display with usage of above primary lenses, please use "scaling" function by masking top and bottom side of the screen without anamorphic lens. If actual lens magnifications for CS display doesn't fit the attached primary lens, please change into a primary lens fittable for CS display.
*7	Compatible third-party film projector lamp bulbs will be listed on "Ulteriori informazioni"
*8	Power cord for Projection head supplied with NC2500S. Power cord for Lamp power supply unit not supplied with NC2500S. Procurement for this cable is required by exhibitors.

Ulteriori informazioni

Ulteriori informazioni

Manufacturer

NEC

mod PROJ

NC2500S

Flusso luminoso

26000 lm @6.0KW Hight eff lamp

2D gain 1 eff 90% @ 14 fL

17 m

3D DOLBY gain 1 eff 90% @5,5 fL

9,0 m

3D gain 2,4 eff 90% @ 5,5 fL

16 m

Xpand gain 1 eff 90% @5,5 fL

11 m

Chip set

Chip: 1.2" DLP Tilt Angle [°]: 12

Risoluzione

2048 x 1080

HFR

NOT Ready

Scambio aria

17 m3/min = 600 CFM = 1020 m3/h (Tamb. >25°C) [BTU]: 30539

Description Tec info

NEC NC2500S DLP Cinema projector

INPUT TERMINAL:

Type	Name	Description	Quantity
Input Terminals	HDSDI port	BNC	2
Input Terminals	DVI port	DVI-digital	2
External control	PC card slot	For compact flash memory card or wireless LAN card	1
	LAN port	RJ-45	2
	USB port	Type A	1
	Serial port(RS-232C)	D-sub (9-pin)	1
	General Purpose Input / Output	D-sub (37-pin)	1
	Remote control connector	Stereo mini	1

Anamorphic lens cannot be used with following primary lenses due to the limitation of the anamorphic lens
(for NC2500S)
1.25 to 1.45 : 1 zoom "L2K-12ZM"
1.45 to 1.8 : 1 zoom "L2K-14ZM"
For Cinema Scope (CS) display with usage of above primary lenses, please use "scaling" function by masking top and bottom side of the screen without anamorphic lens.
If actual lens magnifications for CS display doesn't fit the attached primary lens,
please change into a primary lens fittable for CS display.

The following film projector Xenon lamp bulbs are approved for use in NC2500S.
Bulbs not listed below shall not be approved for use in NC2500S until they are certified by NEC.

Rate Lamp Wattage	Bulb vendor
Rate Lamp Wattage	Ushio	OSRAM	LTI
3.0 KW	UXL-30SC	XBO 3000W / HS OFR XBO 3000W / HSLA OFR	LTIX-3000W-HEHS
4.0 KW	UXL-40SC	XBO 4000W / HS OFR XBO 4000W / HS XL OFR	LTIX-4202W-HEHS
4.5 KW	-	XBO 4500W / HS OFR	-
5.0 KW	UXL-50SC	-	-
6.0 KW	UXL-60SC	XBO 6000W / HSLA OFR	LTIX-6004W-HS
7.0 KW	UXL-70SC	-	-

NEC film lamp adapters are required to attach to above film projector lamp bulbs.

For 3.0KW film projector lamp bulbs
Use NEC optional film lamp adapter
"NC-25CL02"

For 4.0 KW - 7.0KW film projector lamp bulbs
Use NEC standard film lamp adapter
(packed in the NC2500S package)

* NEC shall not guarantee quality and performace of bulbs listed above and shall not warrant bulbs

listed above.

* NEC shall not warrant NEC Lamp house with a reflector damaged by explosion of bulbs listed

above.

Recensioni

Recensisci per primo questo prodotto

Tag prodotto

Usa gli spazi per tag separati. Usa apostrofi singoli (') per frasi.

NEC NC2500S DLP Cinema projector

Altre viste

Prodotti Correlati

Dettagli

Ulteriori informazioni

Tag prodotto